Driven Media 22+ WRX D-Spec Sequential LED Tail Lights

Wanting to spice up the rear end of your WRX? The new Driven Media D-Spec Sequential LED Tail Lights do just that! Not only do they add a unique modern styling to the lighting design, but they also add a sequential turn signal and a startup sequence. These lights are direct replacements and are completely plug and play so the installation is a breeze. There are four variations for you to choose from so you can match them with any color scheme you’ve got going on.

*Includes One Year Manufacturer Warranty

• CBR - Clear Lens, Black Base, Red Diffuser

• SBR - Smoke Lens, Black Base, Red Diffuser

• CBW - Clear Lens, Black Base, White Diffuser

• SBW - Smoke Lens, Black Base, White Diffuser

Installation

• Remove the tail light trim cover by first removing the plastic push clip using a philips head screw driver to loosen it and then pull it out.

• Using a plastic pry tool, wedge it in between the trim piece and the trunk gasket and pry the trim piece straight towards the back of the car and it should pop right out.

• Remove the two 10mm bolts that are holding the tail light in place.

• Grab the tail light by the side that’s closest to the trunk and carefully pull away from the car. You’ll notice that the outer edge is still connected, but as you pull the inner edge out, that will pop the tail light free from the outter tab.

• Once you have the tail lights off the car, unplug the tail light harness.

• Plug your new tail lights in and test to make sure they function correctly and you have the functions set up the way you want.

• Carefully slide the new tail lights into place keeping an eye on the positioning tabs.

• Reinstall the two 10mm bolts and the tail light trim pieces and you’re done!

Note

• Sequential Turn Signal Off - Unplug Brown Wire Connection

• Start Up Sequence Off - Unplug Blue Wire Connection