22+ GR86/BRZ VLAND LED Sequential Tail Lights

Looking to change up the rear end of your car? A set of VLAND tail lights just might be the right choice for you! These tail lights retain the aesthetically pleasing OEM lens shape that flows into the black accent across the trunk, but adds some very unique features you don’t see in other tail light options. The running light includes a matrix design in the lower half of the C-light boomerang and the brake light is broken up into 9 individual LED jewels. You also get a sequential turn signal that goes fully across the top of the tail light.

These tail lights are 100% plug and play and are direct replacements for the OEM tail lights without any additional wiring or modification needed.

*Includes One Year Manufacturer Warranty

Installation

• Remove the tail light trim cover by using a plastic pry tool, wedging it in between the trim piece and the rubber trunk gasket and prying it off of the tail light.

• Remove the three 10mm bolts that are holding the tail light in place. (2 underneath the trim piece you just removed and 1 on the top portion of the tail light)

• Carefully slide the tail light towards the back of the car to remove it. This may take some patience if it’s your first time removing the tail lights.

• Once you have the tail lights off the car, unplug the connection and transfer over the top portion of the tail light that’s held in place with two security screws.

• Plug your new tail lights in and test to make sure they function correctly and you have the functions set up the way you want.

• Carefully slide the new tail lights into place keeping an eye on the positioning tabs.

• Reinstall the three 10mm bolts and the tail light trim pieces and you’re done!

Note

• Sequential Turn Signal On - Unplug Brown Wire Connection

• Start Up Sequence On - Unplug Purple Wire Connection