22+ WRX Tail Light Turn Signal Overlay

OEM 2022+ WRX tail lights utilize a clear section that contrasts the red of the brake light. These tail light overlays allow you to completely transform the look of the rear end by blending that section into the rest of the black accents on the tail lights and trunk giving you an aggressive and sleek appearance while still allowing your lights to shine brightly through.

These overlays are designed and cut in-house using high-quality vinyl to ensure proper fit and finish.

Installation Instructions for DARK SMOKE & LIGHT SMOKE (Dry Application)

• Prior to applying the overlay, make sure the surface is thoroughly cleaned and dry.

• Carefully peel the overlay off of the backing and use the edges of the tail light to line it up. The overlays were designed to have the slightest overlap(thickness of your nail) into the black area of the surrounding tail light area to make installation easier so keep this in mind while installing them. (Each overlay is marked left or right on the backing sheet.)

• We found it easiest to start with the corner on the outer most side and follow the top edge of the clear section until you get to the inner side.

• Once you have successfully positioned the overlay where you want it, use a vinyl squeegee or microfiber to remove any air bubbles.

• We recommend allowing at least 48hrs before washing the car to allow for the adhesive to cure and avoid directly spraying them with a pressure washer.

• The temperature needs to be a minimum of 65°F for proper application.

Installation Instructions for RED & YELLOW (Wet Application)

• Prior to applying the overlay, make sure the surface is thoroughly cleaned.

• Carefully peel the overlay off of the backing. (Each overlay is marked left or right on the backing sheet.)

• Spray the surface of the lens and the overlay with soapy water. (Dawn Soap recommended, just need a drop or two)

• Position the overlay on the lens using the edges of the tail light to guide you. The overlays were designed to have the slightest overlap(thickness of your nail) into the black area of the surrounding tail light area to make installation easier so keep this in mind while installing them.

• Once you have successfully positioned the overlay where you want it, use a vinyl squeegee or microfiber to remove any air/water bubbles.

• We recommend allowing at least 48hrs before washing the car to allow for the adhesive to cure and avoid directly spraying them with a pressure washer.

• The temperature needs to be a minimum of 65°F for proper application.