2022+ GR86/BRZ 3rd Brake Light Overlay
Dark Smoke/Light Smoke Tinted 3rd Brake Light Overlay
Features air release technology for incredibly easy installation
Made in the USA
Comes with 2 pieces
Dark Smoke/Light Smoke Tinted 3rd Brake Light Overlay
Features air release technology for incredibly easy installation
Made in the USA
Comes with 2 pieces
Dark Smoke/Light Smoke Tinted 3rd Brake Light Overlay
Features air release technology for incredibly easy installation
Made in the USA
Comes with 2 pieces
The 22+ GR86 and BRZ has a 3rd brake light built into the spoiler section of the trunk. These overlays allow you to blend it in with the rest of the black accents on the rear of the car making it one cohesive look. This gives the rear end of the car an aggressive and sleek appearance while still allowing the brake lights to brightly shine through.
These overlays are designed and cut in-house using high-quality vinyl to ensure proper fit and finish.
Dark Smoke
The dark smoke option gives you a completely blacked out look that blends the 3rd brake light in with the rest of the gloss black trim that is on the rear of the car. Even though it gives a dark appearance to the light, once you step on the brake, the light is still able to brightly shine through so you’re not hindering your visibility to others.
Light Smoke
The light smoke option darkens the 3rd brake light but still allows a glimpse of the red to come through. It’s a nice subtle change to the rear end of the car to make things a bit more cohesive if the 3rd brake light seems to pop out at you. Even with the overlay installed, you’re still able to clearly see the light shine through once you step on the brake.
Installation Instructions for DARK SMOKE & LIGHT SMOKE (Dry Application)
Prior to applying the overlay, make sure the surface is thoroughly cleaned and dry.
Carefully peel the overlay off of the backing and use either the left or right side of the 3rd brake light up. (Each overlay is marked to show the correct orientation on the backing sheet.)
Follow the top edge of the light until you’re all the way across. *Keep in mind that the vinyl is very pliable and you can stretch it for a perfect fit if needed*
Once you have successfully positioned the overlay where you want it, use a vinyl squeegee or microfiber to remove any air bubbles.
We recommend allowing at least 48hrs before washing the car to allow for the adhesive to cure and avoid directly spraying them with a pressure washer.
The temperature needs to be a minimum of 65°F for proper application.