15-21 WRX/STI Tail Light Overlays

OEM 15-20 WRX and STI tail lights utilize a clear section for the turn signal and reverse light that contrasts the red of the brake light. These tail light overlays allow you to completely transform the look of the rear end by tinting the clear portion of the lens so it doesn’t stick out as much giving you an aggressive and sleek appearance while still allowing your turn signals and reverse lights to shine brightly through.

These overlays are designed and cut in-house using high-quality vinyl to ensure proper fit and finish.

Installation Instructions for DARK SMOKE & LIGHT SMOKE (Dry Application)

• Prior to applying the overlay, make sure the surface is thoroughly cleaned and dry.

• Carefully peel the overlay off of the backing and use the edges of the tail light to line it up.

• Once you have successfully positioned the overlay where you want it, use a vinyl squeegee or microfiber to remove any air bubbles.

• Use a heat gun to heat the vinyl to contour the curves of the edge of the tail lights. There is also a slight indent towards the edge of the lens where the heat will allow the vinyl to lay into easier.

• We recommend allowing at least 48hrs before washing the car to allow for the adhesive to cure and avoid directly spraying them with a pressure washer.

• The temperature needs to be a minimum of 65°F for proper application.

Installation Instructions for RED & YELLOW (Wet Application)

• Prior to applying the overlay, make sure the surface is thoroughly cleaned.

• Carefully peel the overlay off of the backing.

• Spray the surface of the lens and the overlay with soapy water. (Dawn Soap recommended, just need a drop or two)

• Position the overlay on the lens using the edges of the tail light to guide you.

• Once you have successfully positioned the overlay where you want it, use a vinyl squeegee or microfiber to remove any air/water bubbles.

• Use a heat gun to heat the vinyl to contour the curves of the edge of the tail lights. There is also a slight indent towards the edge of the lens where the heat will allow the vinyl to lay into easier.

• We recommend allowing at least 48hrs before washing the car to allow for the adhesive to cure and avoid directly spraying them with a pressure washer.

• The temperature needs to be a minimum of 65°F for proper application.