Driven.Media Tail Light Turn Signal Overlay - 2022+ Subaru WRX

*Installation Instructions for DARK SMOKE & LIGHT SMOKE (Dry Application)*
Prior to applying the overlay, make sure the surface is thoroughly cleaned and dry.

Carefully peel the overlay off of the backing and use the edges of the tail light to line it up. The overlays were designed to have the slightest overlap(thickness of your nail) into the black area of the surrounding tail light area to make installation easier so keep this in mind while installing them. (Each overlay is marked left or right on the backing sheet.)

We found it easiest to start with the corner on the outer most side and follow the top edge of the clear section until you get to the inner side.

Once you have successfully positioned the overlay where you want it, use a vinyl squeegee or microfiber to remove any air bubbles.

We recommend allowing at least 48hrs before washing the car to allow for the adhesive to cure and avoid directly spraying them with a pressure washer.

The temperature needs to be a minimum of 65°F for proper application.

*Installation Instructions for RED & YELLOW (Wet Application)*
Prior to applying the overlay, make sure the surface is thoroughly cleaned.

Carefully peel the overlay off of the backing. (Each overlay is marked left or right on the backing sheet.)

Spray the surface of the lens and the overlay with soapy water. (Dawn Soap recommended, just need a drop or two)

Position the overlay on the lens using the edges of the tail light to guide you. The overlays were designed to have the slightest overlap(thickness of your nail) into the black area of the surrounding tail light area to make installation easier so keep this in mind while installing them.

Once you have successfully positioned the overlay where you want it, use a vinyl squeegee or microfiber to remove any air/water bubbles.

We recommend allowing at least 48hrs before washing the car to allow for the adhesive to cure and avoid directly spraying them with a pressure washer.

The temperature needs to be a minimum of 65°F for proper application.

Confirmed Vehichle Fitment for 22+ WRX Driven.Media Tail Light Turn Signal Overlay

• 2022-2025 Subaru WRX