Verus Engineering Brake Master Cylinder Brace - Scion FR-S / Subaru BRZ / Toyota GT86 & GR86

There are a lot of these things on the market and all of them do pretty much the same thing the same way. I picked this one because I like the fact that it has a cup that provides a larger surface area on the MC.

It's also pretty sleek looking which is a plus if anyone ever looks hard enough to see that it is there.

It mounts in a similar fashion to other such products with the exception of the third mounting point which is a bolt that must pass through the wheel well and thread into the device. It is located behind the front suspension and it is a genuine PITA to install. It isn't necessary but once I got started with the thing I refused to give up on that lase screw.

After much Houdini-like contortion several cuts and scrapes on my hands and quite a bit of profanity I emerged victorious.

There is a simple solution that will avoid this hassle:

Prior to installing the brace get a stud with the proper threads (or just cut off a bolt) and thread it into the brace using a drop of Red Loctite. Pass it through the wheel well during the installation and then thread on a nut and tighten it with a ratcheting wrench. Bob's your uncle.

I contacted Verus and they replied that they appreciated the input. Nothing has changed, of course. But that's par for the course these days.

Nunca pense que algo tan sencillo creara una gran diferencia al frenar en especial en pista se siente muy diferente y da mas seguridad.