Driven.Media D-Spec Sequential LED Tail Lights - 2022+ Subaru WRX

Remove the tail light trim cover by first removing the plastic push clip using a philips head screw driver to loosen it and then pull it out.

Using a plastic pry tool, wedge it in between the trim piece and the trunk gasket and pry the trim piece straight towards the back of the car and it should pop right out.

Remove the two 10mm bolts that are holding the tail light in place.

Grab the tail light by the side that’s closest to the trunk and carefully pull away from the car. You’ll notice that the outer edge is still connected, but as you pull the inner edge out, that will pop the tail light free from the outter tab.

Once you have the tail lights off the car, unplug the tail light harness.

Plug your new tail lights in and test to make sure they function correctly and you have the functions set up the way you want.

Carefully slide the new tail lights into place keeping an eye on the positioning tabs.

Reinstall the two 10mm bolts and the tail light trim pieces and you’re done!

*Note*

Sequential Turn Signal Off - Unplug Brown Wire Connection

Start Up Sequence Off - Unplug Blue Wire Connection

Confirmed Vehichle Fitment for Driven Media 22+ WRX D-Spec Sequential LED Tail Lights

• 2022-2025 Subaru WRX